Epoxy Primer

Type

A two-pack, anti-corrosive paint based on Epoxy Resin with Zinc Phosphate Pigment.

Uses

Protects steel structures in industrial facilities, chemical process plants, Electric power plants, bridge, tank exteriors, Marine weathering, offshore, oil tanks, piping, roofs, water towers & other exposures.

Characteristics

1. Excellent resistance to sea.
2. Excellent rust preventive properties.
3. Tough and hard film with very good adhesion.
4. Excellent resistance to mechanical damage.
5. Very good resistance to oils and many chemicals.

Colour

White, Grey

FINISH(60℃)

Flat

FLASH POINT

Above 20℃ (68℉)

SPECIFIC GRAVITY

1.35㎏/L (Mixture)

VISCOSITY(25℃)

70-85 KU

DRYING TIME (25℃)

Set-to-touch 1 hr.
Dry hard 4 hrs.
Fully cured 7 days.

OPTIMUM FILM THICKNESS

Wet 100-230 microns
Dry 45-100 microns

THEORETICAL COVERAGE

7.7㎡/㎏
10.0㎡/L
0.100 L/㎡(@45 micron DFT)

OVERCOATING INTERVALS

Min 8 hrs.

MIXING RATIO

Base：Hardener＝88：12

VOLUME SOLIDS

Above 45%

POTLIFE

8 hrs. (Mixture) (25℃)

THINNER

No.1005 Epoxy Thinner (SP-12) 0-5% (by wt.)

SUBSEQUENT COATS

No.908 - Blast Primer (SP-01)

SP-04 - Epoxy 4 Zinc Rich Primer, SP

SP-08 - Non-Zinc Shop Primer

SP-09 - Clavo-Zinc Shop Primer Type-2

No.1006- Epoxy 4 Zinc Rich Primer, EP-03

No.1011 - Clavo-Zinc (IZ-01)

FOR AIRLESS SPRAY

Tip No. Graco 319-719, 321-721

STORAGE SHELF LIFE

Minimum 1 year under normal storage conditions.

APPLICATION METHOD

Brush, Roller or Spray.

NOTE

1. Mix base and hardener according to the mixing ratio and stir thoroughly.
2. Avoid applying the paints in rainy or humid weather particularly a wet surface must be thoroughly dried.
3. All equipments must be cleaned immediately after use.
4. When used inside tanks, sufficient ventilation must be provided.
5. When overcoating interval is exceeded paint surface must be roughened to insure adhesion.